Bondstrand 3000, 3200 and 3300

Bondstrand 3000 series are manufactured using aromatic amine or anhydride epoxy. Recommended for water, waste water, moderately corrosive liquids and mild chemicals.

Contact us

Bondstrand(1)

Bondstrand

Bondstrand_Oil_Gas(1)

Tapex_Taper(1)

Description

Bondstrand 3000 series general purpose piping system with working pressure to 450 psig, depending on pipe size.   Dual-angle construction provides high stiffness characteristics and dimensional stability.  Operating surge pressure to 1.5 times rated operating pressure.  No thrust blocks are required at rated system pressure for most buried piping configurations and most soil conditions.  Recommended for water, waste water, moderately corrosive liquids and mild chemicals. 

Features / Benefits

Filament-wound Glassfiber Reinforced epoxy pipe with integral epoxy liner and exterior coating.  Fittings are available as follows: 2 to 6 inch elbows, tees and flanges are  compression-molded, crosses, wyes, laterals and reducers are mitered.  8 “-16”  elbows are filament-wound, tees, crosses, wyes, and laterals are mitered.  Flanges are of two-piece construction – Stub End and Flange Ring (van Stone).

Specifications

BONDSTRAND 3000, 3000A, 3200, 3200A, 3300 AND 3300A SERIES

Size Range:
2″-16″ (50 mm-400 mm)

Inner Corrosion Barrier:
0.020″ (0.5 mm) neat resin liner

Pressure Ratings:
150 to 450 psi. (10 to 32 bar)

Construction:
Continuous Dual-Angle Filament wound, Anhydride or Aromatic Amine (A-Series) cured epoxy

Temperature Range:
-40°F – 150°F (-40°C – 66°C) – Anhydride -40°F – 210°F (-40°C – 99°C) – Aromatic Amine

Joining Method:
Taper/Taper Adhesive Bonded

Fittings:
2″-6″ compression molded, 8″-16″ filament wound. van Stone Flanges.

Chemical Service:
Water, waste water, mildly corrosive liquids, and mild chemicals.

Location

Cesta zmage 35b
1410 Zagorje ob Savi, Slovenia

Phone

Tel.: +386 31 364 610

Email

info@geopipe.si

Send A Message